Filter
Top Products
Tools Needed:
Tools Needed:
10
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Vertical Tracks
BOTTOM SECTION
VERTICAL TRACK
ROLLER
3/16” Drill Bit
Power Drill
7/16” Socket
Driver
Tape Measure
Level
3/8”
TO
5/8”
6
7
Power Drill
7/16” Socket
Driver
LAG
SCREW
QUICK INSTALL
JAMB BRACKET
15R QI12R QI15R FA12R FA
FLAGANGLE LAG SCREW LOCATIONS
BOTTOM
SECTION
5/16” X
1-5/8” LAG
SCREWS
FLAGANGLE
VERTICAL
TRACK
ASSEMBLY
JAMB
BRACKET
CABLE
IMPORTANT: THE TOPS OF THE
VERTICAL TRACKS MUST BE LEVEL
FROM SIDE TO SIDE. IF THE BOTTOM
SECTION WAS SHIMMED TO LEVEL IT.
THE VERTICAL TRACK ON THE SHIMMED
SIDE, MUST BE RAISED THE HEIGHT OF
THE SHIM.
Position the left hand vertical track assembly
over the rollers of the bottom section. Make
sure the counterbalance cable is located
between the rollers and the door jamb. Drill
3/16” pilot holes for the lag screws. Loosely
fasten jamb brackets and flagangles to the
jamb using 5/16” x 1-5/8” lag screws.
Hang counterbalance cable over flagangle.
Repeat for the right side.
Stacking Sections
NOTE: For door section identification see
page 4.
NOTE: Make sure hinges are flipped down,
when stacking another section on top.
Place rollers in hinges tubes of the second
section (lock section).
With assistance, lift second section and guide
rollers into the vertical tracks.
NOTE: Align vertical marks in the upper align-
ment sticker, with the lower alignment sticker
on right hand side on the back of door. Verify
that that the stile patterns on your door sec-
tions are aligned on the outside of the door.
To connect sections, keep sections aligned
and fasten center hinges first and end hinges
last using 1/4” - 14 x 5/8” self-tapping
screws.
Repeat for other section(s) except top section.
LOCK SECTION
327985 NEW 9-04-06
327985 NEW 9-04-06
(2) 1/4” - 14 X 5/8”
SELF-TAPPING SCREWS
327985 NEW 9-04-06
327985 NEW 9-04-06
(2) 1/4” - 14 X 5/8”
SELF-TAPPING SCREWS
ALIGNMENT
STICKERS
END HINGES