Filter
Top Products
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
27
Tools Needed:
INSTALLATION
21
Rear Support
Ratchet Wrench
1/2” Socket
1/2” Wrench
(2) Vice Clamps
Level
Hammer
Tape Measure
KEEP HORIZONTAL TRACK
PARALLEL AND WITHIN 3/4”
MAXIMUM OF DOOR EDGE,
OTHERWISE DOOR COULD FALL,
RESULTING IN SEVERE INJURY OR
DEATH.
Raise the door until the top section
and half of the next section are in a
horizontal position. Do not raise door
any further since the horizontal track
are not yet supported at the rear.
RAISING DOOR FURTHER CAN
RESULT IN DOOR FALLING AND
CAUSE SEVERE INJURY OR
DEATH.
Clamp a pair of vice clamps on the
vertical tracks just above the second
roller on one side, just below the second
roller on the other side. This will prevent
the door from raising or lowering while
installing the rear support.
Using perforated angle,
5/16” x 1-5/8”hex head lag screws
and 5/16” bolts with nuts (may not
be supplied), fabricate rear support
for horizontal tracks. Attach horizontal
tracks to the rear supports with
5/16”-18 x 1-1/4” hex bolts and nuts
(may not be supplied). Horizontal tracks
must be level and parallel with door.
NOTE: If rear supports are to be
installed over drywall, use 5/16” x 2”
hex head lag screws.
Adjust weather seal or door stop (if
necessary). Now permanently attach
the weather seal or door stop to both
door jambs and header. (They were
temporarily attached in PREPARING THE
OPENING on page 10.) Avoid pushing
weather seal or door stop too tightly
against face of door.
PRIOR TO WINDING OR MAKING
WARNING
WARNING
DOOR IN PARTIALLY
OPEN POSITION
VERTICAL
TRACK
VICE
CLAMPS
3/4”
DOOR EDGE
HORIZONTAL
TRACK
WARNING