Filter
Top Products
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
20
Tools Needed:
(1) 1/4”- 20 X 9/16”
TRACK BOLT
(1) 1/4”- 20
FLANGE
HEX NUT
TOP CURVE OF
LOW HEADROOM
HORIZONTAL TRACK
(1) 5/16” WASHER
FLAGANGLE
NOTE: If quick install flagangle was
installed in Step 11, skip this step and
continue with Step 13. If not, complete
this step.
To install horizontal track, place the
curved end over the top roller. Align
the bottom of the horizontal track with
the vertical track. Hand tighten the
horizontal track to the flagangle with
(1) stud plate and (2) 1/4” - 20 flange
hex nuts.
Level horizontal track and bolt the top
curve of the low headroom horizontal
track slot in the flagangle using (1)
5/16” washer, (1) 1/4”- 20 track bolt
and (1) 1/4”- 20 flange hex nut. Repeat
for other side.
NOTE: If an idrive
®
opener will be
installed, position horizontal tracks
slightly above level.
Attaching Horizontal Track to
Adjustable Flagangle
12
7/16” Socket
Ratchet Wrench
7/16” Wrench
Level
Flat Tip
Screwdriver
1/4”-20 FLANGE
HEX NUTS
FLAGANGLE
STUD
PLATE