Filter
Top Products
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
25
Tools Needed:
Tools Needed:
INSTALLATION
18
19
Counterbalance Cables
Vice Grips
3/8” Wrench
Release the vice grips from the ends of
the cables and thread the
counterbalance cables around the back
side of the left cable drum and verify
that there is no cable obstructions. Hook
the cables into the drums. Slide the left
hand cable drum against the left hand
end bearing bracket and tighten the set
screws in the drum to 14-15 ft. lbs. of
torque (Once set screws contact the
tube, tighten screws one full turn).
Rotate the left hand drum and torsion
tube until cable is taut. Attach vice grips
to torsion tube and brace vice grips
against jamb to keep cable taut. Slide
the right hand cable drum against the
right hand end bearing bracket and
rotate drum until cable is taunt. Tighten
set screws in right hand cable drum.
IMPORTANT: CHECK EACH CABLE,
MAKING SURE BOTH ARE SEATED
PROPERLY ON THE CABLE DRUMS AND
HAVE EQUAL CABLE TENSION.
Place vice clamps onto both vertical
tracks just above the third Roller. This
is to prevent the garage door from
raising while winding torsion spring(s).
FAILURE TO PLACE VICE CLAMPS
ONTO VERTICAL TRACK CAN
ALLOW DOOR TO RAISE AND
CAUSE SEVERE OR FATAL
INJURY.
Securing Door
for Spring Winding
Vice Clamp
WARNING
LEFT END BEARING BRACKET
CABLE IN
POSITION
SET
SCREWS
VICE GRIPS
JAMB
LEFT CABLE
DRUM
LEFT CABLE DRUM
CABLE
CABLE
HOOKED IN
CABLE DRUM
TRACK
VICE CLAMPS
ATTACHED TO
INNER RAIL
OF TRACK
PLACE VICE CLAMPS
ABOVE 3RD ROLLER ON
BOTH VERTICAL TRACKS
TORSION
TUBE