Filter
Top Products
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer.
To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at www.wayne-dalton.com
22
Tools Needed:
Tools Needed:
14
15
End Brackets
NOTE: Right and left hand is always
determined from inside the garage
looking out.
End bearing brackets are right and left.
Align bottom edge of left end bracket
with the top edge of the flagangle.
Maintaining this alignment, also align
the right edge of the end bracket with
the right edge of the flagangle.
Secure end bracket to the jamb using
(3) 5/16” x 1-5/8” lag screws as shown.
Repeat for the other side.
Power Drill
7/16” Socket
Driver
Center Bearing Bracket
Power Drill
7/16” Socket
Driver
Level
Tape Measure
Pencil
1/4” Torx Bit
Measure to locate the center of the door
and mark a vertical pencil line on the
mounting surface above the door, to
indicate the center line of the door. Then,
measure from the center of the bearing, in
one of the end bearing brackets, DOWN to
the top of the door. Using that dimension,
measure UP from the top of the door
and mark a horizontal pencil line on the
mounting surface, intersecting the vertical
pencil line. Now align the edge of the center
bearing bracket along the vertical pencil
line on the mounting surface. Center the
bearing bracket on the horizontal line. This
will ensure the torsion tube is level between
the center and end bearing brackets. Attach
the center bearing bracket, in this location,
to the mounting surface, using (2) 5/16”
x 1-5/8” lag screws and (1) 5/16” x 2”
tamper-resistant lag screw.
IMPORTANT: USE THE 5/16” X 2” TAMPER-
RESISTANT LAG SCREW ONLY IF MOUNTING
SURFACE MOUNTED OVER MASONRY.
TAMPER-RESISTANT LAG SCREW MUST BE
ATTACHED THROUGH THE BOTTOM HOLE
OF THE CENTER BEARING BRACKET.
VERTICAL LINE
MOUNTING SURFACE
EQUAL DISTANCE
CENTER OF
END BEARING
BRACKET
HORIZONTAL LINE
CENTER BEARING
BRACKET
CENTER
BEARING
BRACKET
(1) 5/16” X 1-5/8” LAG SCREW
(1) 5/16” X 2”
TAMPER-RESISTANT LAG
SCREW
(1) 5/16” X 1-5/8” LAG SCREW
MOUNTING
SURFACE
HORIZONTAL LINE
VERTICAL
LINE
TOP SECTION
LEFT HAND END
BRACKET
(3) 5/16” X 1-5/8”
LAG SCREWS
TOP SECTION
LEFT HAND END
BRACKET