29
ZIP52 FINISHING - PF .
OPERATING MANUAL
EDITION 01 /2010 PART NO. ZZB012ENG
5.3.4 SHUTTING DOWN AND CLEANING
Note
The device should be cleaned for maintenance purposes, etc. Ensure that no remaining
material dries and sticks.
Procedure:
1. Working breaks -> procedure on chapter 5.3.2.
2. Basic cleaning -> procedure on chapter 5.2.3.
3. Maintain the gun as laid down in the operating instructions.
4. Clean and check the suction system and, in particular, the suction fi lter.
5. When using a high-pressure fi lter: Clean and check the fi lter insert.
6. Clean the outside of the system.
7. Put the whole system back together.
8. Fill the system with solvent as laid down in Paragraph 5.2.3.
7!2.).'
"RITTLElLTERPRESSUREREGULATOR
4HE CONTAINER ON THE lLTER PRESSURE REGULATOR BECOMES BRITTLE
THROUGHCONTACTWITHSOLVENTSANDCANBURST
&LYINGPARTSCANCAUSEINJURY
$ONOTCLEANTHECONTAINERONTHEPRESSUREREGULATORWITHSOL
VENT
3)()??'"
7!2.).'
'ASMIXTURESCANEXPLODEIFTHEREISANINCOMPLETELYlLLED
PUMP
$ANGERTOLIFEFROMmYINGPARTS
%NSURE THAT THE PISTONPUMP AND SUCTION SYSTEMARE ALWAYS
COMPLETELYlLLEDWITHCLEANINGAGENTORWORKINGMEDIUM
$ONOTSPRAYTHEUNITEMPTYAFTERCLEANING
3)()??'"
5.4 STORING FOR LONGER PERIODS OF TIME
When storing the device for longer periods of time it is necessary to thoroughly clean it
and protect it from corrosion. Replace solvent in the material pump with a suitable preser-
ving oil.
Procedure:
1. Carry out Paragraph 5.3.4 „Shutting down and cleaning“, points 1 through 8.
2. Cleaning with preserving agent acc. Paragraph 5.2.3.
3. Protect the air motor with pneumatic oil: connect an oiler to the compressed air inlet
and run for a few double strokes.