Filter
Top Products
34
OPERATING MANUAL
VERSION 10/2013
ORDER NUMBER DOC 2303675
7.3 DECOMMISSIONING AND CLEANING
7.4 LONGTERM STORAGE
Note:
The device should be cleaned for maintenance purposes, etc. Ensure that no remaining
product dries on and sticks to the device.
Procedure:
1 Carry out work interruption -> refer to Chapter 7.2.
2 Carry out basic ushing -> refer to Chapter 6.2.2.
3 Maintain the gun according to the operating manual.
4 Clean and check the suction system and the suction lter.
6 Clean the outside of the system.
7 Put the whole system back together.
8 Fill the system with cleaning agent as described in Chapter 6.2.3 "Filling with working
material".
Brittle lter pressure regulator!
The tank on the lter pressure regulator becomes brittle through contact
with solvents and can burst.
Flying parts can cause injury.
Do not clean the tank on the lter pressure regulator with solvent.
WARNING
Gas mixtures can explode if there is an incompletely filled pump!
Danger to life from ying parts.
Ensure that the pump and suction system are always completely
filled with cleaning agent or working medium.
Do not spray the device empty after cleaning.
WARNING
If storing the system for a prolonged period of time, thorough cleaning and corrosion
protection are necessary. Replace the water or solvent in the material pump with a suitable
preserving oil and ll the separating agent cup with separating agent.
Procedure:
1 Carry out points 1 through 7 in Chapter 7.3 "Decommissioning and Cleaning".
2 Flush with preservative according Chapter 6.2.2.