Filter
Top Products
VIVOTEK
76 - User's Manual
Custom Command
If Custom Camera (scanner) is selected as the PTZ driver, the Preset Position and PTZ Control
Panel on the main page will be disabled� You will need to congure command buttons to control the PTZ
scanner� Click Custom Command to open the Custom Command page to set the commands in the
Control Settings session� Please refer to your PTZ scanner user's manual to enter the commands in the
following elds. Click Save to enable the settings and click Close to exit the page.
►The command buttons will be displayed on the main page:
2010/12/10 17:08:56
NOTE
►If you select DynaDome/SmartDOME, Lilin
PIH-7x00, or Pelco D protocol as the PTZ
driver, the Control Settings column will not
be displayed�
►For all PTZ drivers, a total of ve additional
command buttons can be congured.