Filter
Top Products
VIVOTEK
User's Manual - 73
Transparent HTTP Tunnel: If you want to use your own RS-485 device, you can use UART commands to
build a Transparent HTTP Tunnel� The UART commands will be sent through HTTP tunnel established
between the RS-485 device and the linked camera� For detailed application notes, please refer to URL
Commands on page 109 or http://www.vivotek.com/downloadles/faq/videoserver/UART_HTTP_Tunnel.
pdf�
Preset Positions
If you select DynaDome/SmartDOME, Lilin PIH-7x00, or Pelco D protocol as the PTZ driver and click
the Save button, the Preset Position button will be enabled� Click Preset Position to open the settings
page� You can also select preset positions for the camera to patrol� A total of 20 preset positions can be
congured.
Please follow the steps below to preset a position:
1� Adjust the shooting area to the desired position using the buttons on the right side of the window�
2� Enter a name for the preset position, which allows for up to forty characters� Click Add to enable the
settings� The preset positions will be displayed under the Preset Location list on the left-hand side�
3� To add additional preset positions, please repeat steps 1~2�
4� To remove a preset position from the list, select it from the drop-down list and click Delete�
5� The preset positions will also displayed on the main page� Please refer to the illustration on the next
page�
6� Click Save to enable the settings�
2010/12/10 17:08:56
Functions are the same
as the Control Panel on
the home page
1
2
4
6
2