Filter
Top Products
Section 15 - Zone Programming
15–5
XMIT
TO
CONFIRM
PRESS
✱
TO SKIP
Confirmation Option:
This prompt appears only if you answered
Yes to the first prompt in this section.
T
he system enters a confirmation mode so that the operation of the
actual programmed input can be confirmed. Activate the loop input
or button that corresponds to this zone.
We recommend that you confirm the programming of every
transmitter before proceeding to the next zone.
If the serial/loop number combination transmitted
does not match
the serial number entered, a display similar to the one below
appears. If the loop number does not match, it is also displayed.
Keyd A022-4063
1
Rcvd A022-4064 1
If so, activate the transmitter's loop input or button one or more
times. If a match is still not obtained (i.e., summary display does
not appear), press the [#] key twice and enter the correct loop
input or, if correct, press the [#] key again and then enter the
correct serial number.
Zn ZT RC In:
L
10 03 10 RF:
1s
If the
serial number transmitted matches
the serial number
entered, the keypad beeps 3 times and a summary display appears,
showing that zone's programming. Note that an “s” indicates that a
transmitter’s serial number has been enrolled.
Press [
✱
] to accept the zone information and display the
PROGRAM ALPHA?
prompt.
PROGRAM ALPHA?
0 = NO 1 = YES 0
If you want to program descriptors for zones now, enter
1
(Yes) and
refer to the
ALPHA DESCRIPTOR PROGRAMMING
section
for
available descriptors
.
ENTER ZN NUM.
(00 = QUIT) 11
If you entered
0
(No) above, the system returns you to the
ENTER
ZN NUM.
prompt for the next zone.
When all zones have been programmed, enter
00
to quit
.
When you have finished programming all zones, test each zone using the
system’s TEST mode. Do not use the Transmitter ID Sniffer Mode for checking
wireless transmitting devices, as it only checks for transmission of one zone on
a particular transmitter,
not
the zones assigned to each additional loop.
NOTE:
Following the successful enrollment of each wireless device, remove
ONE
of the
serial number labels from the device and affix it in the appropriate column on the
ENROLLED TRANSMITTERS worksheet of the Programming Form. Then enter the other
information (zone number, zone type, loop number, etc.) relevant to that device. This
information will be useful if any troubleshooting is needed later on. The installer may want
to consider leaving this worksheet at the site (in the panel cabinet).