Vista -10SE Home Security System User Manual


 
Section 14 Data Field Descriptions
14-3
39 AUDIBLE EXIT WARNING (1-Digit Entry)
If enabled, this field provides exit warning sound when armed AWAY
or MAXIMUM.
Warning sound consists of slow continuous beeps until last 5 seconds,
when it changes to fast beeps. The warning sound will end at the
termination of Exit time.
0 = no; 1 = yes.
DIALER
PROGRAMMING
(
40
50)
40 PABX ACCESS CODE (See box at left.)
Enter up to 4 digits if PABX is needed to access an outside line. If
fewer than 4 digits are needed to be entered, exit by pressing
nd
next field number (e.g., 41). To clear entries from field, press
40
.
Fields
40,
41,
42:
Enter up to the number of
digits shown. Do not fill
unused spaces.
Enter 09,
# + 11 for
# + 12 for #
# + 13 for a pause
(2.5 secs)
41 PRIMARY PHONE NO. (See box at left.)
Enter up to 12 digits. If fewer than 12 digits entered, exit by
pressing
and next field number (e.g., 42). To clear entries from
field, enter
41
.
NOTE: Backup reporting (8 calls are made to the secondary phone
number if no kiss-off is received after 8 attempts to primary
number) is automatic only if there is a secondary phone number
(field
42).
42 SECONDARY PHONE NO. (See box at left.)
Enter up to 12 digits. If fewer than 12 digits entered, exit by
pressing
and next field number (e.g., 43). To clear entries from
field, enter
42
. See NOTE in field
41 also.
NOTE: If you wish to send a report to a pager, see field
47
on a following page .
43 SUBSCRIBER ACCOUNT NO. (Enter up to 4 digits)
Enter digits 09, #+11=B, #+12=C, #+13=D, #+14=E, or #+15=F.
Enter
as the fourth digit if a 3-digit account no. (for 3+1 dialer
reporting format) is used. Enter 0 as the first digit of a 4-digit
account no. for nos. 00000999. End field by pressing
(
and press
next field) if only 3 digits are used.
This field is also used as the Long-Range Radio Subscriber Account
No.
45 PHONE SYSTEM SELECT (1-Digit Entry)
If central station receiver is not on WATS line:
0 = Pulse Dial;
1 = Tone Dial
If central station receiver is on WATS line:
2 = Pulse Dial
3 = Tone Dial