Vista -10SE Home Security System User Manual


 
VISTA-10SE Installation and Setup Guide
12-2
If a different Installer code is subsequently programmed, use it instead of 4111 to gain
access to the Programming mode.
When you enter the Program mode, data field
20 is displayed (this is the first data field in
the system). The system now accepts entries for field
20.
Programming a Data Field
1. Press [
]+ Field No. (for example,
21), then make the desired entry.
2. When you have completely programmed a data field, the keypad beeps three times and
then automatically displays the next data field in sequence. To go to a different field,
press [
]
plus the desired field number.
3. If the number of digits that you need to enter in a data field is less than the maximum
digits available (for example, the phone number field), enter the desired data, then press
[
] and the next data field number to be programmed.
4. If you try to enter a nonexistent field, the keypad will display NOT USED EE (Entry
Error). Simply re-enter [
] plus a valid field number.
Reviewing a Data Field/Erasing an Entry
Press [#] + Field No. Data is displayed for that field number. No changes are accepted in
this mode.
To delete an entry in a field, press [
] + Field No. + [
] (applies only to fields
40-
43, and
94).
Interactive Mode Programming (
56,
58,
80,
81, and
82)
Typical prompt displayed
during Interactive mode
programming:
Enter Zn Num.
(00 = Quit) 01
Zone Number
Press [
] + Interactive Mode No. (for example,
56). The
alpha keypad
displays the first of a series of prompts requesting
entries.
A detailed procedure (with displays of prompts) is provided in
later sections of this manual.
Interactive Mode Used to Program
56 Zone Programming Zone characteristics, report codes, alpha
descriptors, and serial numbers
58 Expert Mode
Programming
Zone characteristics, report codes, and
serial numbers.
80 Output Relay
Programming
4204 Relay module
81 Zone List
Programming
Zone lists for relay control
82 Alpha Programming Zone alpha descriptors
Loading Factory Defaults
To load the factory defaults, enter the Programming mode, press
97, then exit the
Programming mode.
Do not press
97 to load defaults if any programming has been done previously. If you do, data
already programmed into the system will be changed!
96
resets all the subscriber account numbers and CSID in preparation for an initial
download.
Exiting the Programming Mode
99
allows
re-entry into the Program mode using
Installer Code + 8 0
.
98
prevents
re-entry into the Programming mode using the Installer code.