Vista -10SE Home Security System User Manual


 
151
SECTION 15
Zone Programming
(
56/
58 Menu Mode)
••••••••••••••••••••••••••••••••••••••••••••••••••
In This Section
About Zone Programming
56 Zone Programming Mode Procedures
58 Expert Programming Mode Procedures
To Remove a Zone
To Delete a Transmitter Serial Number
To Enter and Duplicate Wireless Keys
••••••••••••••••••••••••••••••••••••••••••••••••••
About Zone Programming
56 Zone Programming and
58 Expert Programming are Interactive Menu modes that are
used to program zone numbers, alarm codes, and report codes, and to identify the type of
input device. These modes can also be used for "enrolling" 5800 Series RF Wireless
Transmitter serial and loop numbers.
56 Zone Programming can be used for entering alpha
descriptors for zones (we recommend entering descriptors in menu mode
82). Refer to the
zone assignment table for
56 and
58 on the separate Programming Form.
56 Zone Programming Mode Procedures
NOTE:
Before proceeding, you must program field
22 (RF System) as required.
In the Programming mode, press
56.
SET TO CONFIRM?
0 = NO 1 = YES 0
This display appears upon entry into
56 mode. The default is 0
(No). If you enter 1 (Yes), you are prompted to confirm each
transmitter after entering the serial and loop numbers (at the
XMIT TO CONFIRM prompt later in this procedure).
We recommend that you confirm the programming of every
transmitter.
Enter Zn Num.
(00 = Quit) 10
Zone 10 entered
Zone Number (Zn): Enter the zone number that you wish to
program.
Zone 10 has been entered as an example in display at left.
Press [
] to continue.
ZN ZT RC IN: L
10 00 10 RF:
A summary display appears, showing the status of that zones
programming when using wireless keys.
NOTE:
If you are programming hardwired zones 01-06, the
display appears as follows.
Zn ZT RC In: L
02 00 10 HW:
-
Press [
] to continue.