Filter
Top Products
C. Use only your hand to push in or turn gas control knob. NEVER USE TOOLS. If the
knob will not push in or turn by hand, dont try to repair it, call a qualified service technician.
Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water. Immediately call a
qualified service technician to inspect the appliance and to replace any part of the control
system and gas control which has been under water.
OPERATING INSTRUCTIONS FOR
INTERMITTENT PILOT SYSTEMS
1. STOP! Read the safety information in the users information manual.
2. Set thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which automatically lights the pilot.
DO NOT try to light the pilot by hand. See figure 11, below.
5. Remove access panel (if present)
6. Push in gas control knob slightly and
turn clockwise to "OFF."
7. Wait five (5) minutes to clear out any
gas. If you then smell gas, STOP, Follow B
in the safety information What To Do IF You
Smell Gas. If you dont smell gas, go to the
next step.
8. Turn gas control knob
counterclockwise to ON.
9. Replace control access panel (IF
PRESENT).
10. Turn on all electric power to the
appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate,
follow the instructions To Turn Off Gas To
Appliance and call a qualified service
technician or your gas supplier.
LIGHTING PROCEDURE FOR BOILER WITH
CONTINUOUS PILOT.
FOR YOUR SAFETY READ BEFORE LIGHTING
A. Read warning at the beginning of this instruction.
B. This appliance has a pilot which must be lighted by hand. When lighting the pilot,
follow these instructions exactly.
C. Before lighting, smell all around the appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air and will settle on the floor. Follow B in the
lighting instructions for safety information for what to do if you smell gas on page 10.
D. Use only your hand to push in or turn the gas control knob or reset button. Never use
tools. If the knob or reset button will not push in or the knob will not turn by hand, dont try
to repair it. Call a qualified service technician. Force or attempted repair may result in fire
or explosion. See figure 12, on page 13.
PAGE 12
INTERMITTENT PILOT GAS VALVE
FIGURE 11