Utica PEG-C Thermostat User Manual


 
PAGE 13
E. Do not use this appliance if any part has
been under water. Immediately call a qualified
service technician to inspect the appliance
and to replace any part of the control system
and any gas control which has been under
water.
LIGHTING INSTRUCTIONS FOR
CONTINUOUS PILOT SYSTEM
1. Stop! Read the safety information at
the beginning of this manual.
2. Set thermostat to lowest setting.
3. Turn off all electric power to the
appliance.
4. Remove manifold cover and burner
door, (figures 13 & 15 on pages 14 & 16).
5. Turn gas control knob clockwise to off (See Note #1).
NOTE #1: Some gas control knobs cannot be turned from pilot to off unless knob is
pushed in slightly. Do not force.
6. Wait (5) minutes to clear out any gas. If you smell gas, stop! Follow safety information
What to do if you smell gas, located on page 10 of this manual. If you dont smell gas, go
to the next step.
7. Find pilot. Follow metal tube from gas control. Depending on the model of the boiler,
pilot is mounted on the base or on one of the burner tubes.
8. Turn gas control knob counterclockwise to pilot.
9. Push in gas control knob, or reset button if so equipped, all the way in and hold.
Immediately Light the pilot with a match. Continue to hold the gas control knob or reset button
for about one (1) minute after the pilot is lit. Release knob or button and it will pop back up.
Pilot should remain lit. If it goes out, repeat steps 5 through 10.
* If knob or button does not pop up when released, stop and immediately call your
service technician or gas supplier.
* If the pilot will not stay lit after several tries, turn the gas control knob clockwise
to off (see note #1 above) and call a service technician or gas supplier.
10. Replace burner door and manifold cover, (figures 13 & 15 on pages 14 & 16).
11. Turn gas control knob counterclockwise to "on".
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to the lowest setting.
2. Turn off all electric power to the appliance if service is to be performed.
3. Remove access panel (if present)
4. Turn gas control knob clockwise to off. (See note #1) in the lighting
instructions. Do not force.
CONTINUOUS PILOT GAS VALVE
FIGURE 12