Filter
Top Products
Features and
Benefits
PKG-PRC002-EN6
Integrated Self-Contained
Systems
Integrated Comfort
™
System (ICS)
Trane’s Integrated Comfort
™
system
(ICS) increases job control by combining
IntelliPak
®
Signature Series self-
contained units and a Tracer
®
building
management system. This integrated
system provides total building comfort
and control. Building owners and
managers not only save energy when
using ICS—they have the ability to
automate their facilities and the
convenience of a control system
interface.
Simplifying The Comfort System
Trane’s designers combined new
technology and innovation to bring you
more system capabilities and flexibility.
Our Integrated Comfort
™
system (ICS)
with HVAC equipment is easy to use,
install, commission, and service.
Everything you need to know about your
self-contained VAV system is available
using Tracer
®
, Trane’s family of building
automation products. Tracer
®
is a
software package that minimizes custom
programming requirements and allows
easy system setup and control using
your personal computer. Operating data
from all system components is readily
available for evaluation. You can control,
monitor, and service your facility—all
from your personal computer.
The IntelliPak
®
self-contained unit, as
part of Trane ICS, provides powerful
maintenance monitoring, control, and
reporting capabilities. Tracer
®
places the
self-contained unit in the appropriate
operating mode for: system on/off, night
setback, demand limiting, setpoint
adjustment based on outside
parameters and much more. You can
monitor unit diagnostic conditions
through Tracer such as: sensor failures,
loss of supply airflow, and an inoperative
refrigerant circuit.
IntelliPak
®
Signature Series self-
contained monitoring points available
using Tracer
®
• Compressor on/off status
• Ventilation status
• Condenser water flow status
• Heat status
• Supply air pressure
• Supply air temperature
• Suction temperature of each circuit
• Entering economizer water
temperature
• Zone temperature
• Entering condenser water temperature
• Supply air temperature reset signal
• Morning warmup sensor temperature
• Entering air temperature
Tracer control points for IntelliPak
®
Signature Series Self-Contained Units
• Cooling and heating setpoints
• VAV discharge air temperature
setpoints
• Supply air pressure setpoint
• Cooling and heating enable/disable
• Air economizer enable/disable
• Airside economizer minimum position
• Unit priority shutdown
Commissioning, control, efficiency, and
information…it simply all adds up to one
reliable source…Trane.