Filter
Top Products
BAS-SVP10A-EN 33
Additional Information and Considerations
Figure 6. Area members page (actions > edit configuration)
Heat only/cool only
If the thermostat is configured as cool only, it will not accept its Heat Cool Mode Request to be
controlled to any heating mode. The converse applies if the thermostat is configured for heat only,
it will not accept its Heat Cool Mode Request to be controlled to any cooling mode. If the point is
controlled to an invalid state, it will quickly revert to the previous state.
Parameters not supported
In the Occupancy frame of the Equipment/Space status page, the following properties will not be
displayed:
• Last Controlled
• Controlled by
• Time Remaining
These are parameters that the thermostat points do not support.
Figure 7. Occupancy section of the Equipment/Space status page