Filter
Top Products
EMBROIDERY PATTERN IS MIS-ALIGNED
MACHINE SIDE
Embroidering is
continuing when
thread is tangled.
If the thread remains
tangled, the fabric may
pucker and ruin the
finished embroidery.
Stop embroidering,
remove the hoop and
untangle the thread.
Upper thread tension
is too tight.
This can cause the
material to pucker
and result in uneven
feeding, so reduce the
thread tension.
Refer to pages 92 - 93.
Select a correct
needle.
Refer to pages 96 - 97.
Thread is tangled
somewhere along the
thread path.
If the thread is tangled
on the spool pin or
somewhere along
the thread path, it will
increase the thread
tension and cause the
material to pucker, so
check the thread
HOOP SIDE
No stabilizer attached
when using light or
stretch material.
A
ttach interfacing to
the material.
Refer to pages 66 - 69.
Material has not been
tightly fitted into hoop.
Tighten the material
in the frames so that
it makes a sound
like a drum when the
tightened surface is
tapped with a finger.
Refer to pages 64 - 65.
Embroidery hoop is
not correctly attached.
Attach the hoop
securely to the hoop
bracket with the hoop
mounting screws.
Refer to pages 70 - 71.
Hoop is obstructed
against free motion.
Check around the
hoop and remove
things which cause
obstruction
Needle tip is broken
or needle is too thick.