Filter
Top Products
PREPARING
THE
MACHINE
BEFORE
INSTALLING THE HOOP
1. Turn hand wheel toward you until needle comes to its
highest position.
ATTACHING
AND
REMOVING
EMBROIDERY HOOP
1. Raise presser foot and needle, and push up lever (A) o
f
embroidery foot with your finger and pass embroidery hoop
under it.
To remove, pull the hoop forward to slide it out from
underneath the embroidery foot.
3. Attach hoop to embroidery unit by aligning hoop mounting
screws (D) and the grooves in hoop mounting plate, fitting
projections (C) on hoop bracket into square holes (B) in
hoop mounting plate. Securely tighten hoop mounting
screws (D) with screwdriver.
To remove, loosen hoop mounting screws (D) and remove
the hoop from the hoop bracket.
NOTE: Before attaching small hoop, turn on power switch to
move the carriage to embroidering standby position.
2
1
1
(
D
)
(
A
)
(
B
)
(
B
)
(
C
)
(
D
)
Hoop mounting plate
Plaque de montage de cerceau
Placa de montaje de aro
Carriage
Chariot
Carro