Filter
Top Products
Now you are prompted to select the Program Folder where
the shortcut for the software will be stored.
Simpl
y
click on “Next” to continue.
Finally you are requested to confirm all the selections made
during the installation set-up.
Pressing the “Next” button will finally start the copy and
installation of the FUTURA software files to the given
directory on the hard disk.
A
progress bar will indicate the stage at which the installation
procedure is. It will finish when it has reached to 100%.
The installation procedure is finalizing all required actions and
will automatically close after finish. Please wait for a short
while until this happens.
If the installation utility identifies a lack of available space
on your hard disk, an error message will prompt you to free
some hard disk space before proceeding with the installation.
You can always abort the installation procedure by clicking on
“Cancel”.
CORRECT START-UP PROCEDURE
WHEN EMBROIDERING
The following steps must be followed for proper start-up
protocol. If these steps are not followed precisely, you will
get a “Transmission Pending” error message.
Boot up your computer, but do not open the Futura
software. Next attach the embroidery unit to your sewing
machine and connect the USB cable between your
computer and sewing machine.
1. Turn on your sewing machine. Make sure the needle has
been moved to the hi
g
hest
p
osition b
y
turnin
g
the Hand
4. Double click on the Futura Icon on your desktop to
open up the Futura Software.
5. You are now ready to select and transmit a design to
your machine.
IMPORTANT: For switching from the small to the large
hoop and vice versa close the software, switch the hoop
and the open the software again.