ZIGZAG
STITCHING
SETTINGS :Presser foot - General Purpose Foot
:Thread tension control - S - E
The top thread may appear on the bottom depending on the
thread, fabric, type of stitch and sewing speed, but the bobbin
thread must never appear on the top of the fabric.
ADJUSTING STITCH WIDTH AND
LENGTH
is values set automatically when pattern (No. 03) is set.
The stitch length is 2 mm and the stitch width is about 5 mm.
is the selection range when setting the value manually.
SATIN STITCH
This is a closely spaced attractive stitch for appliqué, bar-tacking,
etc. Slightly loosen top thread tension for satin stitching. Set
length between 0.5 and 2.0.
Use a backing of stabilizer to help avoid stitches puckering the
fabric.
PLACEMENT OF PATTERNS
Stitch width of pattern increases from center needle position
as illustrated.
Under side
Côté de dessous
Reverso
Top side
Côté de dessus
Cara
Center position
Position centrale
Aguja posicionada en el centro
STITCH WIDTH
LARGEUR DU
ANCHO PUNTADA
POINT
mm 0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 6.0
0
0.25
0.5
0.75
1.0
1.25
1.5
1.75
2.0
2.5
3.0