Filter
Top Products
Troubleshooting %I Repair
Figure 15. Remove Cover Panel Fasteners
Figure 16. Lift Top Cover Up And Away From Unit
Figure 17. Remove Right Cover Panel Fasteners
SHREDDING HAMMERS
1. Turn the unit off, allow the rotor to stop completely,
and disconnect the spark plug wire.
2. Remove top cover by prying up panel fasteners with
a flat blade screwdriver. Pry panel fastener heads
up to permit gripping with fingers, then pull fastener
heads to remove fastener (Figure 15).
3. Lift top cover up and away from unit (Figure 16).
3. Remove (2) panel fasteners and (2)
#IO x
5/6”
slot-
ted, hex head screws from right side panel (Figure
17),
and remove panel from unit (Figure 16).
4.
Pull on spring loaded idler to lessen belt tension and
remove belt from pulley. Using a
l/Z”
socket wrench,
remove the (2) 5/l 6-I 6
x
3/4”
hex head cap screws
and (2)
5/16
lock washers that secure the drive pul-
ley bearing plate to the frame (Figure 19).
Figure 16. Remove Right Cover
Figure 19. Remove Drive Pulley Bearing Plate
Screws
25