Filter
Top Products
Operation
2. Remove the spark plug wire from the spark plug to
prevent the possibility of inadvertent starting. On
electric-start models, remove the key to prevent any-
one from inadvertently activating the electric start
feature. Although the unit won’t start with the spark
plug removed, the rotor will turn, and serious injury
could result if your hands are in the area of the rotor
or chipper knives.
3. Inspect the following areas for any remaining materi-
als that may have built up or become caught during
operations:
l vacuum intake nozzle
l vacuum hose intake opening
l chipper cone
l discharge chute
l engine air intake area
l transmission/clutch area
NOTE: Do not spray water on the transmission to clean
it, A/though it is sealed to protect it during normal use,
doing so may force water into the transmission housing,
causing corrosion or transmission failure. Use a small
brush or air stream to clear debris away from this area.
MATERIAL COLLECTION & DISPOSAL
Direct Bagging
Chipped material may be collected using the discharge
collection bag. Check the bag frequently to make sure it
is filled to a level you can comfortably handle when
removing and emptying the bag.
1. To remove the bag, shut the unit off, and let the
rotor come to a complete stop. Unhook the rear and
front support straps, (Figure
8) then loosen the cinch
strap that holds the bag opening to the discharge
chute. (Figure 9)
2. Pull the bag off and away from the discharge tube
(Figure
lo), and using both hands, grip the bag
securely at the front and rear to balance the weight
as you lift it.
3. Place the bag down in the disposal area, and unzip
the zipper opening completely. Lift the bag by the
other end and the contents of
the,bag should empty
out easily.
4. Zip the bag closed, and reinstall in the reverse
sequence followed for bag removal. Tighten cinch
strap securely (Figure 11).
Figure 8. Unhook Support Straps
I
/
I\
Figure 9. Loosen Cinch Strap
Figure IO. Pull Discharge Bag Off Discharge Tube
Figure 11. Tighten Cinch Strap Securely
Direct Discharge
NOTE: The discharge bag may be emptied without
Chipped material may be discharged directly into a
pre-
removing the bag from the Chipper Vacuum by simply
unzipping it and raking the material out by hand. This
selected collection area by installing the discharge
deflector elbow on the discharge chute. When direct
dis-
method is ideal for heavier debris that may make lifting
charge is being used, the deflector elbow must always
and carrying the bag difficult.
be directed away from the operator.
15