Filter
Top Products
42 DOCA0005EN-04
Front panel display and meter setup iEM3100 / iEM3200 / iEM3300 series user manual
Configuration menu for iEM3150 / iEM3350
Wiring
Type
Frequency
Frequency
Date
Date
Time
Time
Contrast
Contrast
Reset Config
Reset Config
Communication
Slave Address
Baud Rate
Parity
Section Parameter Options Description
Wiring Type
3PH4W
1PH2W L-N
1PH2W L-L
1PH3W L-L-N
3PH3W
1PH4W Multi L-N
Select the power system type the meter is wired to.
Frequency Frequency
50
60
Select the frequency of the electrical power system, in Hz.
Date Date DD-MMM-YYYY Set the current date using the specified format.
Time Time hh:mm Set the time using the 24-hour format.
Communication
Slave Address 1 - 247
Set the address for this device. The address must be unique for each device in
a communications loop.
Baud Rate
19200
38400
9600
Select the speed for data transmission. The baud rate must be the same for all
devices in a communications loop.
Parity
Even
Odd
None
Select None if the parity bit is not used. The parity setting must be the same for
all devices in a communications loop.
NOTE: Number of stop bits = 1.
Contrast Contrast 1-9 Increase or decrease the value to increase or decrease the display contrast.
Reset Config Reset Config — Settings are reset to their defaults, except for Password. Meter restarts.