Filter
Top Products
22 DOCA0005EN-04
Hardware and installation iEM3100 / iEM3200 / iEM3300 series user manual
iEM3375 - Direct measurement up to 125 A and LonWorks communications
The various features of the iEM3375 are shown in the diagram below:
DIN rail mounting and dismounting
Mounting the meter on a DIN rail
1. Position the 2 upper slots on the rear of the meter onto the DIN rail.
2. Press the meter against the DIN rail until the locking mechanism engages. The meter is now
attached to the rail. Make sure that the device is not tilted following installation.
A Digital input
B Communication port
C Communications / LonWorks operations LED
D Service pin
E Display for measurement and configuration
F Cancel
G Confirm
H Scroll
I Current and voltage inputs (direct measurement up to 125 A)
J Neuron ID
K Energy pulsing LED (used to verify accuracy)
L Status LED: on/off, error
ON
OK
ESC
Reset
Config
L3’ L3 L2 L1’ L1L1
L2’
N’N
200 /kWh
C/-
DI
Neuron ID: 000000000000
S/N:0000000000
Service
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe electrical work practices.
See NFPA 70E in the USA or applicable local standards.
• This equipment must only be installed and serviced by qualified electrical personnel.
• Turn off all power supplying this device and the equipment in which it is installed before working
on the device or equipment.
• Always use a properly rated voltage sensing device to confirm power is off.
• Replace all devices, doors and covers before turning on power to this equipment.
• Do not exceed the device’s ratings for maximum limits.
Failure to follow these instructions will result in death or serious injury.