Filter
Top Products
Appendix A
Specifications
Controller Requirement
Requires ST-133 or ST-138 with high power modification. Standard ST-133 or ST-138
Controllers cannot meet the NTE’s power requirements.
CCD Arrays
Note:
The following list may not be current. Contact the factory for up-to-date
information on available chips and chip performance specifications.
EEV 100 × 1340
*
EEV 400 × 1340
*
EEV 512 × 512FT CCD57
EEV 1024 × 1024 CCD47-10
EEV 1024 × 1024FT CCD47-20
EEV 1300 × 1340
*
*
TEK 512 × 512D
General
Focal Depth (optical)
Spectroscopy:
0.593"
F-Mount:
46.5mm
C-Mount:
17.5mm
Environmental
Storage temperature: <55°C
Operating environment: 5°C < T < 30°C
Relative humidity: 50%; non condensing
Temperature Stability
±0.04°C over entire temperature range; dark charge stabilized to ±1.2%.
*
Incorporates both high-capacity and low-noise amplifiers. Choice of output amplifier must be
specified at time of ordering.
*
*
Requires /F mount nose and 35mm Vincent shutter. This shutter requires ST-133 having 70 V
shutter drive modification. ST-133s having this modification cannot be used with cameras having
smaller (standard) shutter.