Filter
Top Products
Regency P33 Sunrise
TM
Gas Fireplace
34
INSTALLATION
INSTALLING THE OPTIONAL FAN
120 Volt AC power is needed for the fan switch
and blower. The fan can be hard wired if desired.
The receptacle box should be installed on the
left hand side of the unit by a qualifi ed electrician.
The neutral (wider) slot of the polarized
receptacle should be at the top.
Unit must be grounded at all times. Do
not cut the ground terminal off under any
circumstances.
1) Shut the power off.
2) Remove the faceplate and and lift out
standard fl ush door
3) Turn the fan base on its side (with the base
facing towards you) and then slide the fan
in towards the rear of the unit. Turn the fan
upright and slip it over the two mounting
studs. Take care not to damage the insula-
tion on the fan base. Ensure that the fan
blades do not rub against the valve tub-
ing. Diagram 1.
4) Connect fan ground cable to ground lug.
Refer to wiring diagram.
5) Slide the thermodisc/cover assembly into
the bracket clip on the underside of the
fi rebox. Check that no wire will touch the
hot surfaces. Diagram 2.
Diagram 1
Diagram 2
Diagram 3
Diagram 4
Fan Control Box
Control Mounting Plate
Diagram 5
Diagram 7
Diagram 6
9) Secure the fan wires and power cord by
attaching one of the adhesive backed wire
holder clips (Part #910-199) onto the Fire-
place base. Use the second clip to bundle up
the wires approximately 4" from the control
box. Ensure that there is no interference
with the wires when the faceplate and trim
are installed and that no wire will touch the
hot metal surfaces or sharp edges.
10) Plug the fan power cord into the rear end of
the receptacle box to provide the maximum
clearance.
TO REMOVE THE FAN
1) Shut the power off.
2) Reverse the above instructions.
Note: The bearings are lubricated for life.
Do not lubricate them. Make sure
you vacuum the fan area on a regular
basis.
IMPORTANT:
These fans collect a lot of dust from within
your home. Ensure you maintain these fan
motors on a regular basis by vacuuming
out the fan blades and housing using a soft
brush nozzle.
INSTALLATION
7) Position the control plate assembly on the
left hand side of the fi rebox. Diagram 5
6) Attach the fan control box to the Control
Plate. (Diagram 3 & 4)
8) Secure the control plate assembly with 1
screw as shown in Diagram 6.