Filter
Top Products
Regency
®
L234 Direct Vent Gas Insert 21
INSTALLATION
Attach Left & Right Backing Plate to Faceplate
7) Align the screw holes on the left and right side backing plate with
the oblong openings in the faceplate and secure in place using a
minimum of 2 screws on each side as shown in diagram 4.
Faceplate shown on unit without left and
right side faceplate panels to show mounting
of left and right side backing plate.
Attach Left & Right Corner Backing Plate
9) Place the right side corner backing plate over the top and right side
backing plate. Push in place to secure, see diagram 5. Repeat for
left side.
Completed Backing Plate Installation:
Faceplate shown on unit
without left and right
side panels to show
keyhole mounting.
5) Open the left and right side faceplate panels of the faceplate.
6) Mount the faceplate onto the unit by aligning the 4 key hole slots in
the faceplate with the screws installed to the mounting brackets on
the unit. Tighten screws to secure. See diagram 3.
Diagram 3
Diagram 4
8) Close the left and right side faceplate panels.
Diagram 5
INSTALLATION