Filter
Top Products
8
Place a check mark next to any settings you want to discuss with ORCA, and refer
to these settings when you call them to set up service.
o
House Code
Preferred settin
g
:
House Code A
Can be any House Code (A-P).
Your system can control all mod-
ules set to the same house code.
o
Flashing Alert Unit Code
Preferred settin
g
:
Unit Code 16
Can be any Unit Code (1-16). A
light connected to a module set to
the same House and Unit Codes
you select flashes when the alarm
is tripped, and can be controlled
by the
SECURITY LIGHT
buttons
on the handheld remote. This light
also turns on at dusk and turns off
around 11:30 PM when the sys-
tem is armed in the away mode.
o
Silent Alarm
Preferred settin
g
:
Audible alarm
Can be set to only call ORCA
Monitoring Services and not
sound the siren at all. If you select
silent alarm, you will hear no indi-
cation that the system has been
tripped.
o
Lived-In Look Unit Codes
Preferred settin
g
:
2, 3, and 4
You can select any three Unit
Codes. Modules set to the same
House Code and the three Unit
Codes you select turn on and off
at random times after dusk when
you arm the system in the away
mode. This gives your home a
lived-in appearance.
o
Entry and Exit Delays
Preferred settin
g
:
60-second exit
delay; 30-second entry delay
Each can be set from 0 to 1000
seconds.
o
Dial Delay
Preferred settin
g
:
40 Seconds
Can be set from 0 to 1000 sec-
onds. This sets how long the con-
sole waits after it has been tripped
before it calls ORCA Monitoring
Services.
49-2570.fm Page 8 Wednesday, August 18, 1999 3:59 PM