Filter
Top Products
23
OPERATION
ARMING/DISARMING
THE SYSTEM
You can arm the system three ways:
•Set
INSTALL/RUN 1/RUN 2
on the
console to
RUN 1
or
RUN 2
and
press
ARM
on the console.
•Set
INSTALL/RUN 1/RUN 2
on the
console to
RUN 1
or
RUN 2
and
press
ARM AWAY
or
ARM HOME
on the handheld remote control.
See “Arm Away/Arm Home” and
“Instant/Delay Mode.”
•Set
INSTALL/RUN 1/RUN 2
on the
console to
RUN 1
or
RUN 2
and
press
ARM
on the keychain
remote control.
The console beeps once when you
arm it. When the system is armed, the
RUN 1
and
RUN 2
setting have the
same effect: opening a door or window
with a sensor transmitter attached or
tripping a motion detector sets off the
alarm.
The only difference between
RUN 1
and
RUN 2
is that when the system is
set to
RUN 2
and
not
armed, the con-
sole sounds a pleasant chime when
you open a door or window. When it is
set to
RUN 1
, there are no chimes.
To disarm the system, press
DISARM
on any remote control. The console
beeps twice.
Arm Away/Arm Home
All sensor transmitters arm when you
press
ARM AWAY
. Also, a module set
to the same House and Flashing Alert
Unit Code you selected when you set
up service with ORCA Monitoring Ser-
vices turns on at dusk and off around
11:30 PM and modules set to the same
House Code and Lived-In Look Unit
Codes you selected turn on and off at
random intervals.
If you press
ARM HOME
, only doors
and windows arm. This lets you arm
the system at night without tripping the
motion detector.
Instant/Delay Mode
With
ENTRY
on the handheld remote
set to
INSTANT
(and
DELAY
on the sen-
sor transmitter(s) set to
MIN
), the sys-
tem instantly arms and the alarm
immediately trips if any sensor trans-
mitter reports an intrusion.
With
ENTRY
on the handheld remote
set to
DELAY
, you have a 60-second
exit delay and a 30-second entry delay
before the system arms or trips. A
warning chime sounds during the de-
lay period.
ARM
HOME
ARM
AWAY
WIRELESS
SECURITY
SYSTEM
•
AUTOMATIC
MESSAGE
DIALLER
DISARM
49-2570.fm Page 23 Wednesday, August 18, 1999 3:59 PM