Filter
Top Products
30
Problem Solution
You do not hear a chime from
the console when you press
ARM
to install a remote.
Check if you can arm the system when
INSTALL/RUN 1/
RUN 2
on the console is set to
RUN 1
or
RUN 2
. If you can,
the remote control is already installed and no further ac-
tion is necessary. If not:
1. Set
INSTALL/RUN 1/RUN 2
on the console to
INSTALL
.
2. Press
CODE
(located beneath the label on the
remote control) with a pencil, then press
ARM
a
g
ain.
You do not hear a chime from
the console when you press
TEST
to install a door/window
sensor transmitter or motion
detector.
With
INSTALL/RUN 1/RUN 2
on the console set to
RUN 2
,
check that the console chimes when you press
TEST
on
the sensor transmitter or motion detector. If it does, the
sensor transmitter or motion detector is already installed
and no further action is necessary. If not:
1. Set
INSTALL/RUN 1/RUN 2
on the console to
INSTALL
.
2. Press
CODE
on the motion detector with a pencil or
remove then reinstall the batteries in the sensor
transmitter. Then press
TEST
a
g
ain.
Note:
If the sensor transmitter/motion detector is already
installed, it is installed a
g
ain into the next available zone.
The BATTERY LOW indicator
on the console is on.
Replace the console’s battery.
You lose your remote control. Purchase a replacement remote control (Cat. No. 49-
2591T or 49-2591), and then completely re-install your
system to prevent someone else from usin
g
the lost re-
mote control.
The system arms or disarms
by itself.
A nei
g
hbor mi
g
ht have a compatible system. Re-install
the remotes.
The red indicator on the hand-
held remote control stays on
durin
g
installation.
Press the button located beneath the label with a pencil
and then press
ARM
. If it still stays on, remove the bat-
tery, wait a few seconds, then replace the battery. Press
the button and then
ARM
a
g
ain.
49-2570.fm Page 30 Wednesday, August 18, 1999 3:59 PM