Filter
Top Products
18
TESTING THE SYSTEM
After you complete the quick installa-
tion procedures, follow these steps to
test the system.
Note:
To avoid alarming neighbors, tell
them you are testing the system.
1. Set
INSTALL/RUN 1/RUN 2
on the
console to
RUN 2.
2. Place each door/window sensor
transmitter’s magnet next to its
magnetic switch.
3. Place the motion detector on a
counter top within 100 feet of the
console.
4. Move a door/window sensor
transmitter’s magnet away from
the magnetic switch.
When the system is not armed,
the console chimes every time
someone opens a door or window
with the system in the
RUN 2
mode. The system does not chime
in the
RUN 1
mode.
Replace the magnet next to the
magnetic switch.
5. Press
ARM
on a remote control,
and then move the magnet away
from the magnetic switch again.
The alarm sounds and the lamp
connected to the lamp module
flashes on and off. Press
DISARM
to turn off the alarm, and
LIGHTS
OFF
to turn off the lamp. Replace
the magnet next to the magnetic
switch.
6. Press
ARM
on the remote control,
then walk across the path of the
motion detector’s lens. The alarm
sounds and the lamp connected
to the lamp module flashes on and
off. Press
DISARM
to turn off the
alarm. The console chimes twice.
Press
LIGHTS OFF
to turn off the
lamp.
WIRELESS SENSOR TRANSMITTER
49-2570.fm Page 18 Wednesday, August 18, 1999 3:59 PM