Filter
Top Products
16
5. Place one of the supplied num-
bered stickers on the sensor
transmitter to show its zone num-
ber.
6. Leave the console’s switch set to
INSTALL
to install other accesso-
ries.
Repeat these steps for additional door/
window sensor transmitters.
INITIALIZING THE
MOTION DETECTOR
1. Press the four dots on the battery
compartment cover and slide the
cover down to remove it.
2. Install four 1.5V AA alkaline bat-
teries (Cat. No. 23-552) inside the
motion detector’s battery compart-
ment according to the polarity
symbols (+ and –) marked inside.
3. Be sure the console’s
INSTALL/
RUN 1/RUN 2
switch is set to
INSTALL
.
4. Press
TEST
on the back of the
motion detector. The console
chimes, and the first available
zone indicator lights to show the
console has logged in the motion
detector.
If you do not hear a chime, press
CODE
with a pencil, then press
TEST
again.
5. Looking at the back of the motion
detector, set the switch on the left
side to
1
(see “Mounting the
Motion Detector”).
6. Place one of the supplied num-
bered stickers on the motion
detector to show its zone number.
7. Leave the console’s switch set to
INSTALL
to install other accesso-
ries.
8. Replace the motion detector’s bat-
tery compartment cover.
MOTION DETECTOR
TEST
CODE
2
1
49-2570.fm Page 16 Wednesday, August 18, 1999 3:59 PM