Filter
Top Products
October 10, 2001 9 250-5583
Contour Pellet Stove
Part #811-0860, 3"-3" Top Vent Adapter or Part #812-3570, 3"-6" Offset Collar
1) Put a layer of silicone on the 3" (76mm) exhaust
outlet.
2) Slide the ue adapter onto the rear exhaust outlet.
3) Adjust the assembly to a vertical position.
4) Drill four holes with #26 drill bit (provided) into the back
of the stove using the outer shield as a pattern (make
sure the assembly is vertical).
5) Install the four mounting screws.
6) Drill two holes with #26 drill bit through the Rear
Exhaust Outlet using the two holes already in the short
horizontal pipe in the Top Vent Adapter as a guide.
Install the two screws
7) Install the stove pipe into the adapter (be sure to
silicone all joints).
8) To clean adapter, remove cleanout cover.
NOTES:
The feed adjustment rod is factory set, and should be
adequate for most fuels. However, if the flame height is too
high or too low, follow the instructions below.
Loosen the set screw (Fig. 1) 1/4 to 1/2 turn during set-up
of stove. This will allow movement of the Fuel Adjustment
Rod. Do not re-tighten set screw.
Adjust fuel adjustment rod after the stove has been burning
for 10-15 minutes. The flames should be approximately
4"(102mm) above the firepot at high heat output setting.
TOP VENT FLUE ADAPTER INSTALLATION
FEED ADJUSTMENT
Cleanout Cover
Mount with four
screws
Wing Nut
Fuel Adjustment Rod
FIGURE 1
FIGURE 2
1) Loosen the wing nut.
2) Adjust the fuel adjustment rod upward towards the "+"
symbol, to increase the feed rate and ame height,
or down towards the "-" symbol, to decrease the feed
rate and ame height.
3) Re-tighten the wing nut.
Rear Exhaust
Outlet
Use hole on each
side as drilling guide