October 10, 2001 25 250-5583
Contour Pellet Stove
Latch
Top Bafe
Face of Stove
Second
Notch
Rear Screen Replacement Kit Instructions
Part #812-4510
1. Lift off both side curtains.
2. Unscrew lower screw ONLY on each side curtain
mounting bracket.
3. Detach vacuum switch from rear screen (2 screws).
4. Remove and retain the 10 screws from the existing
rear screen and remove screen from stove. Discard old
screen.
5. Attach new screen to rear of stove using 10 screws
removed in step 4.
6. Re-attach vacuum switch to rear screen.
7. Re-attach lower screw to side mounting brackets.
8. Attach side curtains and align if necessary by adjusting
lower screw on side mounting brackets.
Included in Kit: 1 Rear Replacement Screen
Tools Required: Phillips screwdriver
TOP BAFFLE REMOVAL INSTRUCTIONS
Your new Contour stove has a latch to keep the top bafe from coming out during shipment or when
the heat exchanger scraper rods are pulled.
1) To remove the top bafe for periodic thorough cleaning of the heat exchanger, rst locate the latch. It is located
between the front edge of the top bafe and the inside of the rebox centered from side to side. The latch pivots
up and down.
2) Push the latch up with your nger while sliding the top bafe forward and down. See FIGURE 1
3) To reinstall the top bafe, align the hooks on the bafe with the slots in the bafe hangers, push up and slide back.
See FIGURE 2.
4) Make sure the latch drops back into position, bypassing the rst notch and catching the front edge of the top bafe
with the second small notch.
Latch
Second Notch
FIGURE 1.
FIGURE 2.
Lower mounting
bracket screw
Vacuum
Switch
Mounting
Bracket
