Filter
Top Products
October 10, 2001 24 250-5583
Contour Pellet Stove
1. Unplug stove.
2. Remove both side curtains by opening halfway, then
lifting up and pulling back.
3. Disconnect vacuum hose and both wires (orange and
red) from the vacuum switch so you can remove the top
rear screen.
4. Unscrew and remove top rear screen.
5. Unscrew lower rear screen, and lay it on it's back as
shown in Fig. 1.
Exhaust Blower Replacement Instructions
Part #812-4400
Included in Kit: (1) Blower; (1) Gasket
Tools Required: Phillips Screwdriver; Flathead
Screwdriver or 1/4" Nutdriver.
FIG. 2
6. Remove both wires from exhaust blower (blue and
double white).
7. Remove 6 screws using a athead screwdriver or a
1/4" nutdriver. Retain screws for use on replacement
blower. See Fig 2.
8. Remove exhaust blower and gasket.
9. Install new gasket and blower by reversing steps 1-8.
FEED MOTOR Replacement Instructions
Part #812-4420
FIG. 1
1. UNPLUG THE STOVE.
2. Open the right Side Curtain to expose the Feed Motor.
3. Disconnect the Molex connectors. Remove the two
screws from the Feed Motor Mount. (Figure 1)
4. Pull the Feed Motor/Auger assembly straight out towards
you, being careful not to hit the Control Box.
5. Loosen set screw that secures Auger Shaft to Feed Motor
Shaft. (See Figure 2), Remove 4 screws attaching Feed
Motor to mount. Lift off old motor and replace with new.
Secure with screws. Ensure Auger Shaft set screw aligns
with at side of Feed Motor Shaft.
6. Re-assemble in reverse order.
FIG. 2
Lower Rear Screen
Exhaust
Blower
Remove
wires from
Blower
CONTOUR SHOWN
WITH TOP REAR
SCREEN AND
VACUUM SWITCH
REMOVED.
FIG.1
Molex Connectors
Feed Motor Mount Screws
Auger shaft
set screw
Rectangular
nylon bearing
Feed motor
mounting