Filter
Top Products
October 10, 2001 22 250-5583
Contour Pellet Stove
NOTE: Front Face and Door can be removed from stove
while attached together, or you may leave the Door on
the hinges while you remove the Front Face from the
Door.
1 If leaving the Door on the hinges, hold the Front Face
in place while removing the screws from Grille so that it
does not fall forward and potentially become damaged.
Remove Grille and set aside. See Fig. 1
2. Tilt the top of the Front Face forward until the top rib
clears the door, then slide the face down until the locat-
ing screws on the bottom rib are completely out of the
door.
See Fig. 2
3.
Lay Front Face on protective surface, face side down
Use a small screwdriver or punch to push ller buttons
out. See Fig. 3
NOTE: The holding tabs on the back side of the but-
tons have been bent over to secure for shipping.
You must bend the tabs back up to remove the but-
tons.
4 Touch-up area around holes with paint supplied with
stove.
Kit Contents: Trim Ring (1); 8-32 Nuts (6)
Tools Required: Phillips head screwdriver; 11/32" wrench
or nut driver; small screwdriver or punch.
Locating Screws
(on rib, the two
Locating Screws
(on rib, the two
Rib
Face
Grille
Door
Locating Screws
(on rib, the two
Rib
FIG. 1
TRIM RING INSTALLATION INSTRUCTIONS
Part #811-0820
FIG. 3
FIG. 2