Filter
Top Products
October 10, 2001 10 250-5583
Contour Pellet Stove
Fig. 3
LOG SET PLACEMENT INSTRUCTIONS
Part 811-0851 4 piece Log Set
Part 811-0900 Optional Firepot Twig
The logs are very fragile. You must use extreme
care when handling or cleaning the logs.
Step 1: To expose the rebox open the door.
Step 2: Position the Logs
Place the right rear log as shown. There is a notch in the
bottom of the log for clearance for the Thermocouple and
Thermocouple Cover (ceramic protection tube). Fig. 1
Step 3: Place the twig over the repot. It will be about 2-1/2" above
the repot when in place. Notice the position of the twig as
it rests on the 3 logs in a stable position to prevent it from
falling into the repot. There is also a charred area on the
back of the twig, do not turn it toward the front. Fig. 5
WARNING: Due to the abrasive nature of a pellet stove re, the
logs are not covered under warranty. Any placement variation other
than shown here can cause excessive heat and shall void the stove
warranty.
Fig. 2
Fig. 1
Fig. 4
Fig. 5
notch
Thermocouple
cover
4 PIECE LOG SET INSTALLATION
OPTIONAL FIREPOT TWIG INSTALLATION
Continue placing the last 3 logs around the repot as
show in Fig. 2, 3 and 4. Be careful not to block the drop tube
in the back of the rebox where pellets feed into the repot.
drop tube