Filter
Top Products
R
R
R
August 13, 2009
7034-106F
Page 9
Mt. Vernon Pellet Stove (AE)
READY
71
Set at: 68
12:30 PM
MENU
1. At the starting screen, press “MENU”
button once or twice until “MENU”
screen appears.
. Highlight “FUEL TYPE” using the “UP/
DOWN” buttons to the right side of the
display. Press “SELECT”.
Auto/Manual/Off
User Settings
Fuel Type
MENU
Set Comfort Level
. Scroll down and highlight “HARD-
WOOD PELLET” or your fuel type.
Sunflower Seeds
Wheat
FUEL SELECTION
Softwood Pellet
Hardwood Pellet
5. Press “DONE” to conrm fuel
change.
CONFIRM FUEL CHANGE
Please empty hopper
of old fuel type and
ensure firebox is clean.
Please refer to
section 8 in manual.
DONE
. Highlight “AUTO/MANUAL/OFF”.
Press “SELECT”.
User Settings
Fuel Type
MENU
Set Comfort Level
Auto/Manual/Off
. Highlight “MANUAL”. Press “SELECT”.
AUTO/MANUAL SETTINGS
Manual
Off
Automatic
Manual
CHOOSING FUEL TYPE
TURNING ON APPLIANCE
7. Fill the hopper with fuel. If the hop-
per was completely empty or has run
out of fuel, put approximately 1/ cup
of pellets into the repot for a quick
restart.
8. Be sure the hopper lid and glass
door are both closed.
1. At the starting screen, press “MENU”.
Function Buttons
Buttons
Up
Down
READY
73
Set at: 73
12:30 PM
HEAT OUTPUT
MENU
Room
Temp
Wall Control for Reference
6. Press “DONE” twice or wait 15 sec-
onds for starting screen to reap-
pear.
4.
Press “DONE” twice or wait 15 sec-
onds for starting screen to re-ap-
pear.
READY
71
Set at: 68
12:30 PM
MENU
. Now press “SELECT” to choose new
fuel.
READY
71
Set at: 68
12:30 PM
MENU
1. At the starting screen, press “MENU”
button once or twice until “MENU”
screen appears.
. Highlight “TEMP UNITS F/C” using the
“UP/DOWN” buttons to the right side of
the display. Press “SELECT”.
CHOOSING TEMP UNIT:
°F or °C
5. Press “DONE” twice again, or wait 15
seconds for starting screen to re-ap-
pear.
. Press the “UP” or “DOWN” button
to set desired temperature unit and
press “SELECT”..
USER SETTINGS
Flame Height Adjust
Temp Differential
Temp Units F/C
Auto/Manual/Off
Fuel Type
Set Comfort Level
User Settings
MENU
. Highlight “USER SETTINGS” using the
“UP/DOWN” buttons to the right side of
the display. Press “SELECT”.
L. Quick Start Guide
NOTICE:
Any button pressed will turn on the backlight. Wall control will automati-
cally revert back to the starting screen if there is no activity for 15 seconds; except
for the “CONFIRM FUEL CHANGE” screen.