Quadra-Fire DV400S Indoor Fireplace User Manual


 
DV400S DIRECT VENT ROOM HEATER
March 4, 2002 Page 23 30211C
R
Figure 17 - Removal of Sealed Glass
Firebox Entry
A. Removing the Front Face.
1. Loosen the thumb screw from the bottom of the unit that holds
the front face in position. See Figure 16.
2. Carefully lift the front face up and pull the bottom forward.
Place it in a safe place.
Figure 18 - Log Identification
D. Creating the Coal Bed Look.
Ember Chunks.
Randomly place the ember chunks on the burner tube
between and in line with the two front logs, creating a small
wall of embers. Do not allow the chunks to cover the
burner ports or air holes in the burner tube as this may
restrict air and/or gas flow, creating a less than satisfac-
tory performance. Too much restriction can cause improp-
er combustion and sooting (especially with an appliance
using propane gas).
Mineral wool may be bridged over the chunks for greater
enhancement.
B. Removing the Glass.
3. Remove the glass frame assembly by pulling the latch releas-
es forward and upward. See Figure 17. Lift the glass frame
assembly up, sliding the [3] tabs at the bottom out of the slots.
C. Log Placement.
The logs are shipped in separate packaging. Refer to
Fig. 18 for identification, and Fig 19, 20, and 21 for the
installation process.
Figure 16 - Bottom Thumb Screw
Fig. 19
Rear Log
Placement
Fig. 20
Front Log
Placement
Fig. 21
Top Log
Placement
1. Rear Log
2. Front Log
3. Top Log
1.
2.
3.