Filter
Top Products
R
R
R
September 21, 2006
7014-082B
Page 2
CB 1200 Pellet Stove
D. Fuel Adjustment Rod
The set screw is located at the bottom of the hopper and set
loose at the factory so the fuel adjustment control rod will slide
up and down by only loosening the thumb screw at the top.
See Figure 23.1. Do not re-tighten bottom set screw.
F. Fire Characteristics
A properly adjusted re with the heat output control switch set
on “high” has a short active ame pattern that extends out of
the repot approximately 4 to 6 inches (102 to 152mm). If
the re has tall ames with black tails and seems somewhat
lazy, the feed rate will need to be reduced. This is done by
sliding the fuel adjustment control rod down, which will reduce
the feed. If the re is not 4 to 6 inches (102 to 152mm) tall,
slide the fuel adjustment control rod up to increase the feed.
A medium and low setting will give a shorter ame. The ame
will rise and fall somewhat. This is normal.
Figure 23.1
C. Before Your First Fire
1. First, make sure your appliance has been properly
installed and that all safety requirements have been met.
Pay particular attention to the re protection, venting and
thermostat installation instructions.
2. Double check that the ash drawer and firebox are
empty!
. Check the position of the thermocouple, located above
the repot, and make sure that it protrudes approximately
/4 inch (19mm) into the repot.
4. Close the front door.
IMPORTANT DETAIL: The tip of the thermocouple must
be in contact with the inside end of the thermocouple
cover.
The feed adjustment control rod is factory set, and should
be adequate for most fuels. However, if the flame height is
too high or too low, you will need to adjust the feed rate. Wait
until the appliance has been burning for 15 minutes before
making your adjustments and a
llow 15 minutes for feed
adjustment to take effect.
G. Feed Rate Adjustment Instructions
E. Starting Your First Fire
1. A thermostat is required for proper operation of this
appliance, except for corn. At this time, ll the hopper
with pellets, set the thermostat to its lowest setting. Plug
the power cord into nearby outlet.
2. The exhaust blower will stay on for approximately 10
minutes even though the thermostat is not calling for
heat. This is normal.
. L
ocate the heat output control switch mounted on the
upper right corner of the right side panel. Switch it to
the high setting by pushing the top of the switch in, then
adjust the thermostat to its highest setting. The red call
light located on the upper right corner of the right side
panel will be on. This indicates the thermostat is calling
for heat.
4.
The fuel feed system and the igniter should
now
be on.
5. For your rst re it will be necessary to press the reset
button every two minutes until pellets start to drop into
the repot, then press button 1 more time. This will ll the
feed system and allow the appliance to begin dropping
pellets. The appliance will continue to run as long as the
thermostat is calling for heat.
6. Once the appliance has ignited, let the it burn for
approximately 15 minutes, then set the thermostat to the
desired room temperature. Adjust the heat output control
switch to the desired setting.
1. Loosen the thumb screw.
Figure 23.1
2. Adjust the fuel adjustment control rod towards the "+"
symbol to increase the feed rate and ame height or
towards the "-" symbol, to decrease the feed rate and
ame height.
. Re-tighten the thumb screw.
Fuel Adjustment
Rod
Thumb
Screw
Set Screw