Filter
Top Products
R
R
R
September 21, 2006
7014-082B
Page 17
CB 1200 Pellet Stove
7
Appliance Set-Up
A. Outside Air Kit Instructions
Flex Hose
Hose Clamp
Collar Assembly
Trim Ring
Termination
Cap Assembly
Hose Clamp
Included in Kit: 1 piece of 2 inch x foot ex hose, 2 hose
clamps, 1 collar assembly, termination cap assembly, 1
trim ring, 12 screws.
a. Measure distance from oor to air vent opening in appli
-
ance and mark location on wall.
Use saw to cut opening in wall. Cut a 2-1/2 to inch
(64-76mm) opening on inside wall and a to -1/2 inch
(76-89mm) opening on outside of house.
b. Use hose clamp to secure ex pipe to collar assembly.
c. Slide trim ring over ex pipe and run pipe through wall.
d. Attach hose to outside termination cap with second
hose clamp.
e. Secure termination cap to outside surface.
f. Secure trim ring to interior wall.
g. Snip corners and remove plate. Figure 17.1.
h. Align and secure collar assembly with 2 of the 4 holes
as shown. Figure 17.2
Tools Needed: Phillips head screw driver; wire cutters;
hole saw or jig saw.
CAUTION
Never draw outside combustion air from:
• Wall, oor or ceiling cavity
• Enclosed space such as an attic or garage
Figure 17.1
1. Rear Installation
Snip Corners
and remove
plate
Figure 17.2
Figure 17.3
a. Remove rear screen and set aside.
b. Install cover plate over hole in right rear oor.
c. Cut a 2 inch minimum hole in the oor to accommodate
ex hose.
d. Attach hose to termination cap.
e. Place rope under pedestal to close off air leaks.
Screen
Install Cover Plate
Seal Pedestal with 26 in. Rope
Figure 17.4
2. Floor Installation
NO
NO
Secure Collar