Filter
Top Products
Page 25
32198A February 15, 2002 32198A February 15, 2002
Cape Cod Wood Stove
R
INSTALLATION
BLOWER INSTALLATION & OPERATION
ADJUSTING THE BLOWER SPEED
CONTROL, IF NECESSARY*
NOTE: When the speed control is turned clockwise, it
will click on to high speed. Turn the speed control
clockwise to decrease the speed. At full clockwise,
the blower should blow gently, but should not stop.
1. With the unit plugged in, turn the speed control knob
to slow (full clockwise).
2. With a small screwdriver, adjust the blower speed by
turning the adjustment mechanism through the hole
on the side of the speed control.
3. Adjust the speed so the blower runs slowly, but does
not stop. Turn clockwise to slow the blower and
counterclockwise to increase the speed.
*The blower speed control for this unit is adjusted
at the factory, and normally does not require
further adjustment.
Part 831-1700
The blower is shipped fully assembled
and ready for installation.
1. Remove the three Phillips head screws and
the mounting bar from the outer shield at the
lower back of the stove.
2. Align holes in mounting bar with those on
mounting plate of blower in order to sandwich
the blower mounting plate between the rear
shield and the mounting bar.
3. Align screws with holes in rear shield and
tighten, securing blower to stove.
4. Do not remove ground prong from plug.
Plug blower cord into a grounded outlet. Route
power cord away from stove in such a manner
to avoid heat from the stove, trafc, or other
damage. Do not route cord over or in front
of stove.
BLOWER OPERATING INSTRUCTIONS
1. Initial (cold) start-up: Leave blower off
until your stove is hot and a good coalbed
is established. The blower can be turned
on approximately 30 minutes after loading
the stove with fuel.
2. High burn setting: The blower may be left
on throughout the burn.
3. Medium burn setting: The blower should
be left off until a good burn is established,
then turned on at a medium or high rate.
4. Low burn setting: The blower tends to cool
off the stove. Leave blower off until burn
is well established. Then turn on at your
desired rate.
5. The highest blower speed is obtained by
turning the speed control on and then
adjusting back towards off as far as possible
without turning the blower off. For a low
blower speed, turn the control knob clockwise
as far as possible.
Blower
mounting
plate
Rear
Shield
Mounting
bar