Filter
Top Products
Page 24
32198A February 15, 2002 32198A February 15, 2002
Cape Cod Wood Stove
R
INSTALLATION
OUTSIDE AIR KIT INSTALLATION
1. Remove all materials from packing
box.
2. Mount the ex ange (with pipe tting
extending out), over the intake air
opening at the rear of stove using the
four mounting screws supplied with
kit.
3. Cut a 4” minimum hole in the oor or
wall to accommodate outside air piping.
Use 4” metal flex or rigid piping to
directly connect outside air to the unit
or into vented crawl space. (Do not put
ex into a non-vented crawl space). If
using ex tubing attach cable ties to
secure tubing at both ends. Use the
supplied termination cap with a rodent
screen. Seal between the oor or wall
and the pipe with silicone to prevent
moisture penetration.
Included in Kit: 1 ex ange; 2 cable ties; oustide air termination cap; mounting screws (Discard
the remaining parts).
NOTE 1: An outside air kit is required for Mobile Home Installation.
Use Part #831-1780
NOTE 2: If you plan to install the optional blower and the outside air kit,
complete installation of the outside air kit rst.
NOTE 3: When using Hearth Legs you can install an Outside Air Kit or
Blower but not both.
Items Needed for Installation: UL181 approved 4" (76mm) diameter ex pipe in the length
as required for your installation; Phillips screwdriver; Silicone sealant; Drills and saws
necessary for cutting holes through the wall or flooring in your home. (Obtain sufficient
length for installation).
OUTSIDE AIR
TERMINATION CAP
(contains rodent screen)
FLEX FLANGE