Filter
Top Products
18 C3468M (4/10)
Installing the Dome Drive
1. Perform one of the following options:
• View video using both analog and IP connections: Set the DIP switches on the top of
the Spectra IV dome drive (refer to Figure 12). For DIP switch settings, refer to the labels
located on the top of the dome drive, or refer to Switch Settings on page 28.
• View video using the IP connection: You do not need to set the DIP switches.
NOTE: When connecting more than one Spectra dome to a single controller, terminate the unit
farthest from the controller. To terminate the dome drive set the SW2-10 switch to the ON position.
Figure 12. Setting the DIP Switches
2. Install the dome drive.
a. Align the blue and red tabs with the blue and red labels on the back box.
b. Push in the red tab and insert that side of the dome drive first.
c. Push in the blue tab and insert the dome drive into the back box the remainder of the way.
d. Continue pushing on the ends of the tabs until both sides click firmly into place.
WARNING: Improper installation of the dome drive can be dangerous and can seriously damage
the equipment.