Filter
Top Products
10 C3468M (4/10)
Figure 4. Installing the Plates
5. Attach a conduit fitting (not supplied), lock nut (not supplied), and safety chain bracket (refer to
Figure 2 on page 8).
6. Install a safety chain/cable (not supplied), which will support up to 16 pounds (7.3 kg).
7. Open the hinged door to the back box by pushing the tab lock toward the wall of the unit and lifting
the door open.
8. Pull the wiring into the back box through the conduit fitting.
9. Connect all required wiring (refer to Wiring on page 12).
10. Install the back box by compressing the spring clips and pushing the back box through the hole (refer
to Figure 5).
11. Tighten the screws until you hear a clicking noise.
Figure 5. Installing the Heavy-Duty In-Ceiling Back Box
ì
Back Mounting Plates
î
Ceiling
ï
Mounting Ring