Filter
Top Products
C3468M (4/10) 11
PENDANT, HEAVY-DUTY PENDANT, AND STAINLESS STEEL
1. Install the mount for the pendant dome. Refer to the instructions supplied with the mount.
NOTE: If the mount is outdoors, make sure it is properly sealed to keep moisture out.
2. Open the hinged door to the back box by pushing the tab lock towards the wall of the unit and lifting
the door open.
3. Pull the wiring into the back box.
4. Connect all required wiring (refer to Wiring on page 12).
5. Screw the back box onto the mount (refer to Figure 6). If outdoors, apply thread compound (supplied)
to the threads on the back box.
NOTE: Thread compound must be applied. Not doing so may prevent the units from being separated
in the future.
Figure 6. Attaching the Pendant Back Box to the Mount