Filter
Top Products
36
DVI-D input/output Digital RGB:
XGA (1024768), WXGA (1280768), SXGA (12801024), WSXGA+ (16801050),
UXGA (16001200), WUXGA (19201200)
Vertical frequency: 60 Hz
Video format inputs:
Digital RGB: 1080/50p, 1080/59.94p
Vertical frequency: Same as system formats
Video format outputs:
Digital RGB: 1080/50p, 1080/59.94p, 1080/50i, 1080/59.94i, 720/50p, 720/59.94p
p The input and output of analog signals are not supported.
p Output support the high‑resolution multi view mode:
Signals are output with a high resolution even when SD is set as the system mode.
(When high‑resolution multi view mode has been enabled, MV is selected as the DVI‑D OUT
output, and it is not possible to select MV with SDI OUT.)
p This connector does not support the HDCP technologies.
Standard input/output: 1 line each (DVI‑D IN, DVI‑D OUT)
p The DVI‑I connector cable cannot be used.
p For the DVI‑D connector cable, use a cable with a length of up to 5 m (16.4 ft).
Reference input/output In gen‑lock mode: Black burst or Tri‑level Sync input signals (with loop‑through)
In internal sync mode: Black burst output signals 2
p Same field frequencies as those of the system formats supported.
p With the 1080/23.98PsF and 1080/24PsF formats, only gen‑lock mode supported.
p With the 1080/23.98PsF format, black burst with 10F‑ID (SMPTE318M standard met) or TRI
signals supported.
Video delay time When the frame synchronizer setting is “Off” and the up‑converter setting is
“Off”.
1 line (H)
When the frame synchronizer setting is “On” or the up‑converter setting is “On”. 1 frame (F)
p When the signals have passed through PinP, DVE, multi view, down‑converter, DVI‑IN or
DVI‑OUT, a maximum delay of 1 frame is applied in each case.
Control I/O LAN 10BASE‑T/100BASE‑TX (For IP control)
Connecting cable:
LAN cable (category 5 or above),
max. 100 m (328 ft), STP (Shielded Twisted
Pair) cable recommended
p When connecting to a hub (switching hub),
use a straight cable.
Use a crossover cable when connecting the
unit and computer on a 1:1 basis without
going through a hub.
p Use with the same segment is recommended
for the equipment which is connected to the
unit.
If the unit is connected to equipment whose
segments are different, events dependent
upon the settings inherent to the network
equipment, for instance, may occur so
thoroughly check the connections with the
equipment to which the unit will be connected
prior to the start of operation.
RJ‑45
EDITOR Used to control an editor
RS‑422 control connector
Communication format
Baud rate : 38400 bps
Character length : 8 bit
Parity : Odd
Stop bit : 1 bit
Flow control : None
D‑sub, 9‑pin, female
4. Specifications