Filter
Top Products
25
1. Parts and their functions
1-1-6. Positioner area
POSITIONER
X/Y
Z
Positioner (POSITIONER) [X/Y]
These are used when performing the settings below.
PinP1, PinP2 position settings
Wipe start position setting
Target patterns:
WIPE1: 5
WIPE2: 4, 5, 6, 7
SQ1: 5
SQ2: 4, 5, 6, 7
Refer to “1‑2. Wipe” (<Operations and Settings>
Operating Instructions).
Flying key position setting
Chroma key marker position setting
In each case, the settings take effect only when the
following menu items have been selected.
During the time it takes for the unit to start up after its
power is turned on, the unit detects the positions of the
positioners and sets them to their center positions.
Do not touch the positioners until the unit has started up.
Note
Rotary encoder [Z]
This is used to set the PinP size, flying key size or to select
the chroma key area.
In each case, the settings take effect only when the
following menu items have been selected.
Positioner Rotary encoder
Valid menu
X/Y Z Switch
PinP1, PinP2 Position adjustments Size adjustments
(size increased by rotating the
encoder clockwise and reduced
by rotating it counterclockwise)
Hold switch down to restore
initial values (X/Y, Z).
All PinP1 and PinP2 menus
WIPE (BKGD) Start position
adjustments
— Hold switch down to restore
initial values (X/Y).
Background/WIPE Position
Background/SQ Position
WIPE (KEY) Start position
adjustments
— Hold switch down to restore
initial values (X/Y).
Key/WIPE Position
Key/SQ Position
Chroma key Selection position
adjustments
Selected area size adjustments
(size increased by rotating the
encoder clockwise and reduced
by rotating it counterclockwise)
Execute sampling Chroma Key/Sample1
Chroma Key/Sample2
Flying key Position adjustments Size adjustments
(size increased by rotating the
encoder clockwise and reduced
by rotating it counterclockwise)
Hold switch down to restore
initial values (X/Y, Z).
Key: Flying Key