Filter
Top Products
29
2. Preparations
2-2. Basic menu operations
This section describes the basic operations of the menus which are displayed on the built‑in display.
For more details, refer to <Operations and Settings>.
For the menu configuration, refer to “5. Setting menu table” in <Operations and Settings>.
2-2-1. Menu configuration and operations
1 Press the [MENU MODE] button to show the menu on the built-in display.
Refer to “1‑1‑5. Display area”.
2 Select the menu for each function using the menu selection buttons (MENU SELECT) that corresponds
to the function concerned.
Each time the button is pressed, the menu of the function displayed at the top of the button and the menu of the function
displayed at the bottom are switched.
The button of a selected menu lights up in amber.
4
INS
Live Switcher AV-HS410
U1 U2 U3 U4 U5 U6 U7 U8
USER BUTTON
MENU
MODE
PICT
DSK
TIME
PLUGIN
BKGD
CBGD
KEY
CHRKEY
PinP1
PinP2
MENU
HOLD
XPT
MV
IN
OUT
CONFIG
SYS
MENU
OFF
WFM
VECT
VMEM
SD Card
SHOT
EVENT
DISPLAY MENU SELECT
MENU
INPUT
VMEM
BKGD
PATT
KEY
PATT
TAKE
ENTER
�/
+
PAGE
PLAY
REC
STOP
XPT
DSBL
＜
CLIP 1
STILL 1
MEMORY / WIPE PATTERN / 10 KEY
＜＜
TRIM OFF
＞＞
CLIP 2
STILL 2
REV
TRIM OUT
TRIM IN
9
PASTE
6
MOD
3
REV
C
UNDO
8
COPY
5
DEL
2
＞
.
＞＞
7
NEW
1
＜
0/10
＜＜
STORE
RE
CALL
EDIT
DEL
SHOT
MEM
EVENT
MEM
PLUGIN
MEM1
PLUGIN
MEM2
＞
F1 F2 F3 F4 F5
21
3
3 Use the rotary encoders [F1] to [F5] to select more detailed settings.
[F1] : Turn this rotary encoder to select the sub menu.
[F2] to [F5] : Use (press or turn) these rotary encoders to set the parameters.
For further details, refer to the next page.
Operate here
using [F1].
Operate here
using [F2].
Operate here
using [F3].
Operate here
using [F4].
Operate here
using [F5].
Sub menu
Parameter setting area
p The Input and Output menus will differ depending on whether an option board has been installed in the unit.